Brake Pad: Service and Repair

Fig. 4 Removing caliper mounting bolts:

1. Raise and support vehicle and remove wheel.
2. Remove caliper mounting bolts, Fig. 4.
3. Remove caliper from knuckle, taking care not to drop inside pad. Hang caliper aside.
4. Remove outside pad.

Fig. 5 Installing outside pad:

5. Install caliper and inside pad to knuckle, Fig. 5.

Fig. 6 Installing inside pad & caliper:

6. Install caliper and inside pad to knuckle, Fig. 6. Position outer springs over caliper as shown.
7. Torque caliper bolts to 17.5-26 ft. lbs.
8. Install front wheel.
9. Lower vehicle and perform brake test.