Instrument Cluster R & I

"C" & "K" Models

1) Disconnect battery ground cable and remove headlight switch control knob and radio control knobs. Remove steering column cover, and 8 screws attaching bezel. Remove bezel.

2) Reach up under instrument panel cluster and disconnect speedometer by depressing tang on rear of speedometer head and pulling cable free.

3) Remove cluster from vehicle for further disassembly as required. To install, reverse removal procedure.

"G" Models

1) Disconnect battery ground cable. Reach up under instrument panel cluster and disconnect speedometer cable by depressing tang while pulling cable free.

2) Remove clock set stem knob. Remove bezel attaching screws and remove bezel. Remove lower cluster attaching screws. Pull top of cluster away from instrument panel and lift out bottom of cluster. Unplug harness connector from printed circuit and remove cluster.

3) To install, reverse removal procedure making sure that clips at top of cluster slip into instrument panel opening after bottom of cluster is installed.

"S" Models

1) Disconnect battery ground cable. Remove 5 screws and remove instrument cluster trim plate. Remove instrument panel face plate. Remove lens and speedometer cable.

2) Disconnect electrical connector from instrument cluster and remove cluster. To install, reverse removal procedure.