Headlight Switch R & I

"C" & "K" Models

1) Disconnect battery ground cable. Reach up behind instrument cluster, depress shaft retaining button and remove switch knob and rod. Remove cluster bezel screws at left end, and pull out on bezel. Hold switch nut with wrench.

2) Disconnect multiple wiring connectors at switch terminals. To remove switch, turn while holding switch nut. To install, reverse removal procedure.

"G" Models

1) Disconnect battery ground cable. Reach up behind instrument panel and remove switch knob and shaft by depressing retaining button. Remove switch retaining nut from front of panel and push switch through panel opening.

2) Remove multiple electrical connector at switch terminals. To install, reverse removal procedure making sure ground ring is installed on switch.

"S" Models

1) Disconnect battery ground cable. Pull headlight switch to "ON" position. Reach up under instrument panel and depress switch shaft retainer button while pulling on the switch control shaft knob.

2) Remove 3 screws and remove switch trim plate. Use a large bladed screwdriver to remove light switch ferrule nut from front of instrument panel. Disconnect connector from bottom of light switch. To install, reverse removal procedure.