All Other Models
Using Remover and Installer tool (J-9519-10 & Components) remove old bushing by turning bolt. Press new bushings into control arm using Remover & Installer tool (J-9519-10).
TIGHTENING SPECIFICATIONS
| Application | Ft.Lbs. (N.m) | ||
|---|---|---|---|
| Cavalier, Cimarron, Firenza, Skyhawk & J2000 | |||
| Shock Absorber | |||
| Upper End | 7 (13) | ||
| Lower End | 35 (47) | ||
| Stabilizer Bar-to-Axle | 10 (14) | ||
| Stabilizer Bar-to-Control Arm | 13 (17) | ||
| Control Arm-to-Body Bracket | 68 (93) | ||
| Brake Line Bracket-to-Frame | 8 (11) | ||
| Brake Line Bracket-to-Control Arm | 11 (15) | ||
| Hub and Bearing Assembly-to-Rear Axle | 37 (50) | ||
| All Other Models | |||
| Shock Absorber | |||
| Upper End | 7 (13) | ||
| Lower End | 43 (58) | ||
| Track Bar | |||
| Century, Celebrity, Ciera & 6000 | 44 (60) | ||
| Skylark, Citation, Omega & Phoenix | 35 (47) | ||
| Brake Line Bracket | 8 (11) | ||
| Lower Control Arm-to-Bracket | 78 (115) | ||
| Lower Control Arm-to-Underbody | 28 (38) | ||