V8 Engines: 1969: Firebird

Disconnect battery cable and remove fan shield and distributor cap. On air conditioned cars, remove compressor from brackets and set aside (do not disconnect compressor entirely). Check routing and movement of hoses and wiring harnesses in order to raise engine (approximately 4 1/2"). Raise engine and drain crankcase. Disconnect steering idler arm from frame. Remove exhaust crossover pipe, or if dual exhaust, disconnect exhaust pipes from manifolds. Remove starter assembly, starter motor brackets, and flywheel cover. Position a suitable engine lifting tool (with cross bar) to engine, bolt tool to timing chain cover. Using a suitable jack, support engine at lifting tool and remove motor mounts. Loosen rear transmission mount.

NOTE: It may be necessary to remove this mount and rest rear of transmission on crossmember, to obtain clearance.

Remove oil pan bolts and raise engine straight up approximately 4 1/2" and forward approximately 1 1/2". Remove oil pan by rotating clockwise (facing forward) to clear oil pump.

NOTE: If performing any work other than oil pan gasket replacement, remove jack and support engine with suitable blocks of wood.