LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1968 >> Chevy II 2.5L Eng >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> CHEVROLET 4 & 6 Engines >> Distributor Drive Shaft Lower Bearing >> Installation

Distributor Drive Shaft Lower Bearing: Installation

Drive new thrust washer into place with Tool J-9535. Using Tool J-9535 with driver-bolt in the driver handle, install driver into new bushing from large inside diameter. Drive bushing into position.

NOTE: Proper position of bushing is determined when tool bottoms against cylinder block. Withdraw tool from bushing. If bushing seizes on installer arbor, remove tool with slide hammer. Bushing will not be damaged and tool is designed for this purpose.
scientia non olet · About LEMON Manuals