LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1968 >> Chevy II 2.5L Eng >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> CHEVROLET 4 & 6 Engines >> Crankshaft Pulley (4 CYL.) >> Installation

Crankshaft Pulley (4 CYL.): Installation

Coat hub seal contact area with engine oil, position hub on crankshaft(key aligned) and drive hub onto shaft with Tool J-5590 (or suitable tool) until hub bottoms against crankshaft gear.

NOTE: Crankshaft extends through hub and tool must be used to ensure seating hub properly on shaft.

Install pulley and tighten mounting bolts securely.

scientia non olet · About LEMON Manuals