LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1968 >> Camaro Base, 2D Convertible, 6.5L Eng, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> CHEVROLET V8 Engines (283, 302, 307, 327, 350 & 400) >> Cylinder Head >> Installation

Cylinder Head: Installation

NOTE: Use sealer on STEEL gaskets only. Coat both sides of gaskets. Do not use sealer on composition STEEL-ABESTOS gaskets.

Use gasket sealer, install head on dowel pins in block, coat all cylinder head bolt threads with suitable oil and water sealing compound (Molykote), tighten all bolts finger tight.

NOTE: On 302", 327" & 350" engines, intermediate length bolts are used in Nos. 14 & 17 positions.

Torque all bolts evenly, @ little at @ time, in sequence shown in diagram to correct torque listed. Retorque head bolts after engine is warmed up.

scientia non olet · About LEMON Manuals