Camshaft Bearing Replacement
Install front and rear bearings first. Front and rear bearings act as @ guide for installation tool. Center the No. 2 and 3 bearings being pulled into place.
CAUTION:
Make sure oil holes in bearings line up with oil holes in cylinder block.
When installing end plug, install flush to 1/32" deep to maintain level surface on rear of cylinder block.
CAMSHAFT SPECIFICATIONS
| Engine | Journal |
|---|---|
| 1964-66 | |
| All | 1.8682-1.8692" |
| 1967 | |
| 283", 302", 327" (210. 275, 300 HP) | 1.8682-1.8692" |
| 327" (325, 350 HP) & 350" | 1.9482-1.9492" |
| 1968-69 | |
| All | 1.8682-1 8692" |
| 1970 | |
| 307" & 350" | 1 8682-1.8692" |
| 400" | 1.9487-1.9497" |
| 1971-73 | |
| 307" & 350" | 1.8682-1.8692" |
| 400" | 1.9482-1.9492" |