"G" & "P" Models (1973-74)
Remove steering wheel, directional signal switch cancelling cam and spring. Remove column to panel trim plate (if equipped). Disconnect directional signal switch wiring harness at half-moon connector. Pry wiring harness protector out of column retaining slots. Mark location of each wire in half-moon connector, then remove each individual wire from connector using suitable tool. Insert tool into connector and push in until tool bottoms. Remove tool and pull wire from connector. Remove directional signal lever screw and remove lever. Push in on hazard warning knob and unscrew to remove knob. On Tilt Column only, remove automatic transmission selector dial screws (if equipped) and remove dial and indicator. Remove cap and dial illumination bulb from housing cover. Unscrew and remove tilt release lever. Use suitable puller tool to remove signal housing cover and remove three signal switch mounting screws, then carefully remove switch assembly from column while guiding wiring harness through opening in shift lever housing.