"C" & "K" Models (1973-74)

Remove steering wheel, remove column to instrument panel trim cover. Remove three cover screws and lift cover off shaft.

NOTE: Cover screws have plastic retainers on back of cover to avoid need of completely removing screws.

Using suitable tool, compress lock plate by turning center post nut clockwise, then pry round wire snap ring out of shaft groove and discard ring, lift lock plate off end of shaft. Slide directional signal cancelling cam, upper bearing preload spring, and thrust washer off end of shaft. Remove directional signal lever screw and remove lever. Push in hazard warning knob and unscrew knob. All Columns , pull switch connector out of bracket on jacket and wrap upper part of connector with tape to prevent snagging of wires during switch removal. Tilt Columns , position directional signal and shift housing in "low" position. Remove harness cover by pulling toward lower end of column, be careful not to damage wires. Remove three switch mounting screws and pull switch straight up, guiding wiring harness and cover through column housing.