Front & Rear Suspension: Description

Independent front suspension is used on all models. Each wheel is attached to frame by means of a steering knuckle, upper and lower control arm, and ball joint assembly. Front wheels are held in proper relation by linkage which attaches to steering knuckle. Inner end of lower control arm is connected to frame with rubber pivot bushings and outer end is connected to steering knuckle by a ball joint. Inner end of upper control arm is attached to cross shaft, which bolts to frame. Outer end of upper arm is attached by a ball joint to steering knuckle. Side roll stability is maintained with stabilizer shaft, supported by brackets at each frame side rail (forward of springs). End of stabilizer shaft is connected to lower control arm. Coil springs are located between each frame side rail and lower control arm. Front shock absorbers are located within spring.