Circuit/System Verification
WARNING: This page is about a different car, the 2023 GMC Sierra 3500 HD and 2023 GMC Sierra 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P0602 is not set.
- If the DTC is set
- Perform all necessary programming and setup procedures for the control module: K71 Transmission Control Module
- Verify the DTC does not set.
- If the DTC sets - Replace the component: K71 Transmission Control Module
- Go to next step: If the DTC does not set
- All OK.
- Go to next step: If the DTC is not set
- Verify there are no other DTCs set, except for DTC P0601, P0603, P0604, P0606, P0607, P062F, P16F3.
- If any other DTCs are set
- Go to next step: If no other DTCs are set
- Verify DTC P0601, P0603, P0604, P0606, P0607, P062F, P16F3 is not set.
- If any of the DTCs are set
Replace the component: K71 Transmission Control Module
- Go to next step: If none of the DTCs are set
- If any of the DTCs are set
- All OK.