High/Low Planetary Carrier Assembly Identification
The first-design light-duty 3-pinion high/low planetary carrier (1) can be identified as having a 30 tooth design with an inside diameter (a) of 61.3 mm (2.41 in). In addition, the first-design carrier can also be identified by the presence of a recessed washer pocket (3) at the rear thrust washer location.
The second-design light-duty 3-pinion high/low planetary carrier (2) can be identified as having a 29 tooth design with an inside diameter (b) of 60.2 mm (2.37 in). In addition, the second-design carrier can also be identified by the lack of a recessed washer pocket (4) at the rear thrust washer location.
The first-design heavy-duty 5-pinion high/low planetary carrier (1) can be identified as having 5 pinions and a 30 tooth design with an inside diameter (a) of 61.3 mm (2.41 in).
The second-design heavy-duty 6-pinion high/low planetary carrier (2) can be identified as having 6 pinions and a 29 tooth design with an inside diameter (b) of 60.2 mm (2.37 in).