LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> XT5 Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transmission - 10L1000 (MGM MGU) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P30BD >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2023 GMC Sierra 3500 HD and 2023 GMC Sierra 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify there are no DTCs set related to the following component/system:
    • K20 Engine Control Module
    • Serial Data
    • Go to next step: If a related DTC is not set 
  3. Clear the DTCs.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 
    1. Ignition/Vehicle - Off
    2. Replace the component:K20 Engine Control Module
    3. Operate the vehicle within the Conditions for Running the DTC.

      Verify the DTC does not set.

      • If the DTC sets - Replace the component:K71 Transmission Control Module
      • Go to next step: If the DTC is not set
    4. All OK.
    • Go to next step: If the DTC is not set 
  5. All OK.