LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> XT5 Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 633 (Automatic Transmission - 9T60 (M3G) Or 9T65 (M3W) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P175E >> Circuit / System Verification

Circuit / System Verification

WARNING: This page is about a different car, the 2021 Cadillac XT6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

This DTC is always set in combination with other DTCs.

  1. Verify DTC C005A, C012A, C0035, C0036, C003A, C0040, C0041, C0045, C0046, C0050, C0051, C0055, C0245, C0299, C1207, C1208, C1221, C1222, C1225, C1226, C1232, C1233, P0121, P0122, P0123, P0222, P0223, P057B, P057C, P057D, P057E, P05DC, P05DD, P05DE, P05E0, P0506, P0507, P0708, P0716, P0717, P0721, P0722, P0723, P0746, P0747, P0776, P0777, P077C, P077D, P0796, P0797, P07BF, P07C0, P0960, P0962, P0963, P0964, P0966, P0967, P0968, P0970, P0971, P16A0, P16A1, P16A2, P172A, P172B, P176B, P176C, P176D, P178F, P17C4, P17D3, P2122, P2123, P2127, P2128, P2135, P2138, P2534, P2714, P2715, P2718, P2720, P2721, P2723, P2724, P2727, P2729, P2730, P2732, P2733, P2736, P2738, P2739, P2805, P2812, P2814, P2815, P2820, P2821, P281B, P281D, P281E, P2824, P2826, P2827 is not set.
    • Go to next step: If no DTC is set 
  2. Verify the scan tool parameter: Shift Limiting Active Reason = Not Activated
    • If not the specified state 
    1. Verify there are no DTCs / symptoms related to the following system / component, if equipped:
    • B107 Accelerator Pedal Position Sensor
    • B21A Brake Fluid Pressure Sensor
    • B22 Brake Pedal Position Sensor
    • B303 Transmission Range Sensor
    • B5LF Wheel Speed Sensor - Left Front
    • B5LR Wheel Speed Sensor - Left Rear
    • B5RF Wheel Speed Sensor - Right Front
    • B5RR Wheel Speed Sensor - Right Rear
    • If a DTC or symptom exists 

      Repair or replace as necessary

    • Go to next step: If no DTC or symptom exists 
  3. Verify the following conditions do not exist:
    • Engine Torque = Low or Unstable
    • Engine Speed = Low or Unstable
    • If a condition exists 

      Refer to:

    • Go to next step: If no condition exists 
  4. All OK.