Rear Seat Removal and Installation (60 Percent Seat)

WARNING: This page is about a different car, the 2021 Cadillac XT6. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Rear Seat Track Cover
2	Rear Seat Bolt [ 5x ] CAUTION: Refer to Fastener Caution . Tighten in sequence 45 N.m (33 lb ft)
3	Rear Seat Procedure Disconnect electrical connections, if applicable. Fold the rear seat back cushion down to gain access to the rear seat bolts. Disconnect the recliner cable from the release lever cable equalizer. Lift the carpet flap to access, slide the retainer door open and disconnect the cable. With the aid of an assistant remove the rear seat, by lifting and pulling the seat upward to disengage it from the floor.

Callout

Component Name

Rear Seat Track Cover

Rear Seat Bolt [ 5x ]

CAUTION:

Refer to Fastener Caution .

Tighten in sequence
45 N.m (33 lb ft)

Rear Seat

Procedure

Disconnect electrical connections, if applicable.
Fold the rear seat back cushion down to gain access to the rear seat bolts.
Disconnect the recliner cable from the release lever cable equalizer. Lift the carpet flap to access, slide the retainer door open and disconnect the cable.
With the aid of an assistant remove the rear seat, by lifting and pulling the seat upward to disengage it from the floor.