Installation Procedure
WARNING: This page is about a different car, the 2021 Cadillac XT6. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transmission range selector cable bracket (1).CAUTION:
Refer to Fastener Caution .
- Install the transmission range selector lever cable bracket bolts (2) and tighten to 22 N.m (16 lb ft).WARNING:
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.
- Connect the electronic transmission range selector manual park release cable terminal (3) to the transmission manual shift lever (2).
- Install the electronic transmission range selector manual park release cable bolt (1) and tighten to 9 N.m (80 lb in).
- Install the engine control module bracket.