LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> XT5 Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Supplemental Restraints System) >> Repair Instructions >> Airbag Sensing and Diagnostic Module Replacement

Airbag Sensing and Diagnostic Module Replacement

WARNING: This page is about a different car, the 2020 Cadillac XT5. However, it is still accessible from the selected car via links, so may be relevant.
GM4297542Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Do not strike or jolt the inflatable restraint Sensing and Diagnostic Module (SDM). Before applying power to the SDM, make sure that it is securely fastened. Failure to observe the correct installation procedure could cause Supplemental Inflatable Restraint (SIR) deployment, personal injury, or unnecessary SIR system repairs.

WARNING:

Refer to SIR Warning .

Preliminary Procedures

  1. Disable the SIR system. SIR Disabling and Enabling 
  2. Remove the front floor console rear air duct-forward of auxiliary blower. Front Floor Console Rear Air Duct Replacement (with CJ4 Rearward of Auxiliary Blower) , Front Floor Console Rear Air Duct Replacement (with CJ4 Forward of Auxiliary Blower) , and Front Floor Console Rear Air Duct Replacement (without CJ4)
1 Airbag Sensing and Diagnostic Module Nut [3x]
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Airbag Sensing and Diagnostic Module

Procedure

  1. Disconnect the electrical connectors.
  2. Perform the necessary programming and setup procedure: Control Module References
  3. Enable the SIR System. SIR Disabling and Enabling 
scientia non olet · About LEMON Manuals