Body Hinge Pillar Garnish Molding Replacement
WARNING: This page is about a different car, the 2020 Cadillac XT5. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of GENERAL MOTORS COMPANY
|
| Callout |
Component Name |
| 1 |
Body Hinge Pillar Garnish Molding Procedure
- Starting at the rear of the garnish molding, pull upward at the B-Pillar joint to disengage garnish molding.
- Work your way forward disengaging all of the garnish molding clips then pull rearward to disengage the clip on the forward vertical wall.
- Disconnect electrical connector if vehicle has lighted body hinge pillar garnish molding.
- Reposition the front floor panel carpet as needed.
|