Installation Procedure

Rear Brake Hose - Install
Courtesy of GENERAL MOTORS COMPANY

Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2) - Install NEW [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Brake Hose Fitting Bolt (1) - Install and tighten 44 N.m (32 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Hose Bracket Nut (1) - Install and tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
Bleed the brake system. Hydraulic Brake System Bleeding (Manual without JEO) , or Hydraulic Brake System Bleeding (Pressure without JEO) , or Hydraulic Brake System Bleeding (Pressure with JEO)
Install the tire and wheel assembly. Tire and Wheel Removal and Installation
Remove the support and lower the vehicle.