Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Thoroughly clean the brake master cylinder reservoir and the brake master cylinder body to remove any dirt and debris.
- Using a suitable tool, remove and properly dispose of the brake fluid from the brake master cylinder reservoir.
Front End Sheet Metal Cross Brace (3) - Remove - Front End Sheet Metal Cross Brace Replacement (Impact Bar Bracket) , or Front End Sheet Metal Cross Brace Replacement (Plenum)
Brake Master Cylinder Reservoir Bolt (3) - Remove
- Lift the front of the brake master cylinder reservoir (1) upwards to clear the brake master cylinder reservoir grommets and release from the hold down clip (2).
Brake Master Cylinder Reservoir Grommet (1) - Remove and DISCARD [ 3x ]
- Transfer components as needed.