Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation
Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
- Brake Hose Retainer (2) - Remove
Brake Hose Fitting Bolt (1) - Remove
- Rear Brake Hose (2) - Remove
- Plug the caliper inlet to prevent brake fluid loss and contamination.
- Rear Brake Hose Fitting Gasket (3) - Remove and DISCARD [ 2x ]