Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
For an overview of the component/system, refer to Fuel System Description
| Component | Description |
|---|---|
| G12 Fuel Pump | The component has a 3-phase motor. The control module converts the DC voltage from the battery to 3-phase AC to power the motor. |
| K111 Fuel Pump Driver Control Module | The control module contains a microprocessor used to process input data to control outputs. The control module communicates with the engine control module via serial data. |
When the ignition is turned On, the ECM sends a 12 V signal to the control module K111 to enable the fuel pump. If the engine is not started, the control module K111 turns the fuel pump Off after 6 s.