Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle & All vehicle systems - Off
- Disconnect the electrical connector: X2 @ K20 Engine Control Module
- Test circuit 5294 for an open/high resistance between the test points: Ignition circuit terminal X2 37 @ Control module harness & Output terminal @ Fuse
- If 2 Ω or greater
Repair the open/high resistance in the circuit:
- Go to next step: If less than 2 Ω
- If 2 Ω or greater
- Replace the component: K20 Engine Control Module