Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On / Vehicle - In Service Mode
Verify no other DTCs are set.
- If any other DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If no other DTCs are set
Verify the scan tool parameter: Throttle Body Idle Air Flow Compensation = Less than 90%
- If 90% or greater
  Refer to Throttle Body Inspection and Cleaning
- Go to next step: If less than 90%
Engine - Idling - At normal operating temperature.
Verify the scan tool parameter: Engine Speed = - 100 to + 200 RPM of the Desired Idle Speed
- Go to next step: If not the specified state
  Go to next step: Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- Go to next step: If the DTC sets
  Go to next step: Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
All OK.