Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the electrical connector: Q17 Fuel Injector
- Test for 2 to 3 Ω between the test points: Control circuit terminal 1 & Control circuit terminal 2
- If not between 2 and 3 Ω
Replace the component: Q17 Fuel Injector
- Go to next step: If between 2 and 3 Ω
- If not between 2 and 3 Ω
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: Q17 Fuel Injector
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.
NOTE:
The specified resistances are valid for components at room temperature.