LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT5 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.0L (LGY)) >> Repair Instructions >> Valve Stem Oil Seal and Valve Spring Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4166267Courtesy of GENERAL MOTORS COMPANY

    Use the EN-46116  Valve Stem Seal Remover/Installer (1) to install the valve stem seal (2).

  2. GM4166266Courtesy of GENERAL MOTORS COMPANY

    Valve Spring (2) - Install

  3. Valve Spring Retainer (1) - Install
  4. GM4166262Courtesy of GENERAL MOTORS COMPANY

    Install the EN-46335-A  On-Vehicle Valve Spring Compressor (1) above the applicable cylinder as shown.

  5. Tighten the EN-46335-A  On-Vehicle Valve Spring Compressor bolt (2).
  6. Install the valve spring keepers (3).
  7. EN-46335-A  On-Vehicle Valve Spring Compressor - Remove
  8. Disconnect the EN-39313  Spark Plug Port Adapter from the compressed air source.
  9. EN-39313  Spark Plug Port Adapter - Remove
  10. Spark Plug - Install - Gas Engine Ignition Spark Plug Replacement
  11. Valve Rocker Arm-Right Side - Install - Valve Rocker Arm Replacement - Right Side 
  12. GM4117498Courtesy of GENERAL MOTORS COMPANY

    EN-46106  Flywheel Holding Tool (1) - Remove

  13. Camshaft Carrier-Right Side - Install - Camshaft Carrier Resealing - Right Side 
  14. Starter - Install - Starter Replacement (LSY) , or Starter Replacement (LGY)
scientia non olet · About LEMON Manuals