Disassemble Procedure
WARNING: This page is about a different variant/trim than selected.
Engine Block Oil Gallery Plug Cap (1) - Remove [ 2x ]
- Engine Block Oil Gallery Plug M16 (2) - Remove [ 2x ]
- Cylinder Head Locating Pin (3) - Remove [ 2x ]
- Knock Sensor Bolt (4) - Remove
- Knock Sensor (5) - Remove
- Engine Oil Pressure Sensor (6) - Remove
- Engine Block Core Hole Plug (7) - Remove
- Engine Block Oil Gallery Plug M16 (8) - Remove
- Piston Oil Nozzle Bolt (9) - Remove [ 3x ]
- Piston Oil Nozzle (10) - Remove [ 3x ]
- Engine Front Cover Stud (11) - Remove [ 3x ]
Cylinder Head Locating Pin (1) - Remove [ 2x ]
- Engine Block Core Hole Plug (2) - Remove
- Crankshaft Position Sensor Bolt (3) - Remove
- Crankshaft Position Sensor (4) - Remove
- Knock Sensor Bolt (5) - Remove
- Knock Sensor (6) - Remove
- Knock Sensor Heat Shield Bolt (7) - Remove [ 2x ]
- Knock Sensor Heat Shield (8) - Remove
- Engine Block Oil Gallery Plug M16 (9) - Remove
- Engine Coolant Temperature Sensor (10) - Remove
- Crankshaft Rear Oil Seal Housing Locating Pin (11) - Remove [ 2x ]
- Engine Block Oil Gallery Plug M16 (12) - Remove [ 2x ]