Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Camshaft Position Actuator (1) - Remove [ 2x ] - Camshaft Position Actuator Replacement - Bank 2
Camshaft Carrier Bolt (1) - Remove [ 4x ]
- Camshaft Bearing Cap Bolt (2) - Remove [ 4x ]
- Camshaft Bearing Cap (3) - Remove
- Dowel Pin (4) - Remove
- Camshaft Bearing Cap Bolt (5) - Remove [ 12x ]
- Camshaft Bearing Cap (6) - Remove
- Camshaft Bearing Cap (7) - Remove
- Intake Camshaft - Left Side (8) - Remove
- Exhaust Camshaft - Left Side (9) - Remove
NOTE:
Laser Etched or ID flats- Correct Camshaft Location - Bank 2 (C)
NOTE:
Laser Etched or ID flats- Correct Camshaft Location - Bank 2 (D)