Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
Laser Etched or ID flats- Correct Camshaft Location - Bank 2 (C)
Intake Camshaft - Left Side (1) - Install
- Make sure the camshaft flats with laser etched markings are straight up in relation to the cylinder head and that the crankshaft is in the stage 1 position. The crankshaft key way will be at approximately the 11 o'clock position. Timing Chain Alignment Diagram
- Ensure the flat is facing upward when installed to help when installing timing chains.
- Exhaust Camshaft - Left Side (2) - Install
- Make sure the camshaft flats with laser etched markings are straight up in relation to the cylinder head and that the crankshaft is in the stage 1 position. The crankshaft key way will be at approximately the 11 o'clock position. Timing Chain Alignment Diagram
- Ensure the flat is facing upward when installed to help when installing timing chains.
Camshaft Bearing Cap (1) - Install
- Camshaft Bearing Cap (2) - Install [ 2x ]
- Camshaft Bearing Cap Bolt (3) - Install and hand tighten [ 12x ]
Dowel Pin (1) - Install [ 2x ]
- Camshaft Bearing Cap (2) - Install
- Camshaft Carrier Bolt (3) - Install and hand tighten [ 4x ]
- Camshaft Bearing Cap Bolt (4) - Install and hand tighten
- CAUTION:
Refer to Fastener Caution .
Camshaft Bearing Cap Bolt (1) - Tighten in sequence
- First Pass: 6 N.m (53 lb/in)
- Final Pass: 45 degrees
- Camshaft Carrier Bolt (2) - Tighten in sequence [ 4x ]
- First Pass: 6 N.m (53 lb/in)
- Final Pass: 45 degrees
- Camshaft Bearing Cap Bolt (3) - Tighten in sequence [ 12x ]
- First Pass: 6 N.m (53 lb/in)
- Final Pass: 60 degrees
Camshaft Position Actuator (1) - Install [ 2x ] - Camshaft Position Actuator Replacement - Bank 2
NOTE:
Laser Etched or ID flats- Correct Camshaft Location - Bank 2 (D)