Cylinder Heads

The cylinder heads are a two piece design consisting of a head and a camshaft carrier which are cast aluminum with powdered metal valve seat inserts and valve guides. The two piece design allows for the Active Fuel Management (AFM) System. The cylinder heads also feature integrated exhaust manifolds; the exhaust manifolds are incorporated into the head casting. Two intake valves and two exhaust valves are actuated by roller finger followers pivoting on a stationary hydraulic lash adjuster (SHLA). In the LGY engine, the valves and seats are constructed with specialized materials and coatings, and the exhaust valves are sodium filled for robustness with the high temperature turbocharged environment. The cylinder heads also feature a "high-tumble" port design, and are sealed with LGY specific head gaskets. The head gaskets are also specific to the LH and RH sides.

Separate exhaust and intake camshafts are supported by bearings machined into the camshaft carrier. The front camshaft bearing cap is used as a thrust control surface for each camshaft. Each spark plug is shielded by a tube that is pressed into the cylinder head. Each spark plug ignition coil is also mounted through the spark plug tube. The LGY engine uses specific spark plugs and a different spark plug gap from other HFV6 engines. The engine coolant temperature (ECT) sensor is mounted in the thermostat housing near the flywheel end of the engine. With direct injection, the high pressure injectors are located in machined bores below the intake ports. A stainless steel, high pressure fuel rail is attached to the intake side of the head. The LGY engine has unique higher-flow injectors and fuel pump. The cylinder head has a larger bore for the new larger diameter fuel pump follower that operates the higher-flow pump. The fuel injectors are retained to the fuel rail in a new "twist-lock" retention scheme that does not require special tools for service.