Case Extension Assembly Installation
WARNING: This page is about a different variant/trim than selected.
The seal is reusable, inspect the seal and replace if damaged.
- Automatic Transmission Case Extension Seal (1) - Install
- Automatic Transmission Case Extension (2) - Install
- Automatic Transmission Case Extension Bolt (3) - Install and tighten in sequence [6x] - Fastener Specifications
CAUTION:
Before removing or installing the automatic transmission case extension, place the transmission in a holding fixture with the transmission in a vertical position and the case extension facing up. Failure to do so may result in transmission internal damage.
NOTE:
Ensure the park pawl is not engaged.
CAUTION:
Refer to Fastener Caution .