Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Remove the oil fill cap.
Intake Manifold Cover Bolt (1) - Remove [2x]
- Lift up on the front of the intake manifold cover (2).
Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Remove
Electrical Connector (1) - Disconnect [2x]
- Positive Crankcase Ventilation Tube (4) - Disconnect - Plastic Collar Quick Connect Fitting Service
Retainer (1) - Unclip
Camshaft Position Actuator Magnet Bolt (1) - Remove [4x]
- Camshaft Position Actuator Magnet (2) - Remove [2x]
- Camshaft Position Actuator Magnet Gasket (3) - Remove and DISCARD [2x]
Timing Chain Upper Cover Bolt (1) - Remove [9x]
- Timing Chain Upper Cover Bolt (2) - Remove
- Timing Chain Upper Cover (3) - Remove
- Timing Belt Front Upper Cover Seal (4) - Remove and DISCARD
Positive Crankcase Ventilation Valve (1) - Remove and DISCARD