Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Upper Intake Manifold Cover (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Intake Manifold Cover Stud (2) - Install and tighten [3x] - Fastener Specifications
Intake Manifold Cover Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Canister Purge Pump (2) - Install
Evaporative Emission Canister Purge Pump Bolt (1) - Install and tighten [3x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Engine Wiring Harness (4) - Reposition
Retainer (3) - Install [4x]
Electrical Connector (2) - Connect [2x]
Engine Wiring Harness Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Throttle Body Electrical Connector (1) - Connect
Courtesy of GENERAL MOTORS COMPANY

Radiator Surge Tank Inlet Hose (3) - Reposition
Retainer (2) - Install [3x]
Evaporative Emission Canister Purge Tube (1) - Connect
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Pipe (2) - Connect
Fuel Feed Pipe (1) - Connect
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe Bolt (1) @ Evaporative Emission Canister Purge Pump - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Ensure the intake manifold cover insulator retainers fully engage the intake manifold cover studs.

Intake Manifold Cover Insulator (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Cover Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Install
Courtesy of GENERAL MOTORS COMPANY

Push down on the front of the intake manifold cover (2).
Intake Manifold Cover Bolt (1) - Install and tighten [2x] - Fastener Specifications
Install the oil fill cap.
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
Pressurize the fuel system and inspect for leaks.