Removal Procedure

WARNING:

Refer to Rear Compartment Lid Hold-Open Device Warning .

Courtesy of GENERAL MOTORS COMPANY
NOTE:
- Right side shown, left side similar.
- Use a small flat-bladed tool to disengage integral tabs on cargo tie down loop bolt cap
Cargo Tie Down Loop Bolt Cap (1) - Remove [2x]
Cargo Tie Down Loop Bolt (2) - Remove [2x]
Cargo Tie Down Loop (3) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Panel Trim (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Use a small flat-bladed tool to disengage integral tabs on rear end trim finish panel opening cover (1).
Rear End Trim Finish Panel Opening Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

With a flat bladed plastic trim tool, disengage the integral clips.
Rear End Trim Finish Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Carefully manipulate the deck lid hinge opening of the rear compartment side trim past the hinge cover.

Rear Compartment Side Trim Insulator Retainer (1) - Remove [4x]
Rear Compartment Side Trim-Left Side (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Carefully manipulate the deck lid hinge opening of the rear compartment side trim past the hinge cover.

Rear Compartment Side Trim Insulator Retainer (1) - Remove [4x]
Rear Compartment Side Trim-Right Side (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

WARNING:
Refer to Rear Compartment Lid Hold-Open Device Warning .

Using the appropriate tool, remove the rear compartment lid hinge torque rod (1) on the left side.
Courtesy of GENERAL MOTORS COMPANY

Using the appropriate tool, remove the rear compartment lid hinge torque rod (1) on the right side.