Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Windshield Wiper Arm Finish Cap - Left Side and Right Side (1) - Remove [2x]
Windshield Wiper Arm Nut - Left Side and Right Side (2) - Remove [2x]
Windshield Wiper Arm - Left Side and Right Side (3) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Apply two layers of masking tape around the top edge of the service part to prevent paint damage.
Air Inlet Grille Panel Extension - Left Side and Right Side (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Hood Rear Outer Air Inlet Seal Retainer - Left Side and Right Side (1) - Remove [4x]
Hood Rear Outer Air Inlet Seal - Left Side and Right Side (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Compartment Side Sight Shield Retainer (1) - Remove [2x]
Front Compartment Side Sight Shield (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Grille Panel Retainer (1) - Remove [6x]
Disconnect the windshield washer nozzle hose from the windshield washer pump hose.
Lift the front edge of the air inlet grille panel (2) and slide the panel forward from both hood hinges to remove.
Courtesy of GENERAL MOTORS COMPANY

Hood Hinge Nut (1) - Remove [4x]
With the aid of an assistant, remove the hood (2).
Courtesy of GENERAL MOTORS COMPANY

Active Hood Hinge Actuator Nut (1) - Remove [2x]
Disconnect the electrical connector.
Active Hood Hinge Actuator (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Hood Hinge Bolt (1) - Remove [3x]
Hood Hinge (2) - Remove