Removal Procedure
Reposition the seat as necessary to access the retaining clips.
- Using a flat - bladed plastic trim tool, release the retaining clips.
- Front Floor Console Extension Panel - Right Side (1) - Remove
Reposition the seat as necessary to access the retaining clips.
- Using a flat - bladed plastic trim tool, release the retaining clips.
- Front Floor Console Extension Panel - Left Side (1) - Remove
Front Floor Console Rear Cover Bolt (1) - Remove [2x]
- Front Floor Console Rear Trim Panel (2) - Remove
- Disconnect the electrical connectors.
Front Floor Console Bolt (1) - Remove [6x]
- Front Floor Console Bracket Bolt (2) - Remove [2x]
- Disconnect the front floor console harness connector (3).
Disconnect the front floor console harness connector (1).
Release the tabs (1) on both sides of the front floor console.
- Slide the front floor console (2) enough to clear the instrument panel lower center trim panel.
Front Floor Console Variable 1 Liner (1) - Remove
- Front Floor Console Trim Plate Bolt (2) - Remove [2x]
Front Floor Console Trim Plate (1) - Remove
- Disconnect the electrical connectors.
Wireless Charging System Module Bolt (1) - Remove [4x]
- Wireless Charging System Module (2) - Remove
- Disconnect the electrical connector.
Front Floor Console Cup Holder Bolt (1) - Remove [8x]
Front Floor Console Cup Holder (1) - Remove
- Disconnect the electrical connectors.
Front Floor Console Armrest Bolt (1) - Remove [7x]
- Disconnect the electrical connectors.
- Front Floor Console Armrest (2) - Remove
Automatic Transmission Control Bolt (1) - Remove [4x]
- Automatic Transmission Electronic Control (2) - Remove
- Disconnect the electrical connector.
Release the clips on the front floor console wiring harness (1).
- NOTE:
Quantity of clips and routing of the front floor console wiring harness may vary based on option content.
Release the wiring harness clips and remove the front floor console wiring harness (1).