Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

Electronic Transmission Range Selector Manual Park Release Cable Clamp Bolt (1) - Remove
Electronic Transmission Range Selector Manual Park Release Cable (2) @ Transmission - Remove
Courtesy of GENERAL MOTORS COMPANY

Unclip the electronic transmission range selector manual park release cable (1) retainer from the electronic transmission range selector manual park release cable bracket.
Remove the electronic transmission range selector manual park release cable (2) from the transmission.
Courtesy of GENERAL MOTORS COMPANY

Electronic Transmission Range Selector Manual Park Release Cable Guide Nut (1) - Remove
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Heater and Air Conditioning Evaporator and Blower Module (2) - Remove - Heater and Air Conditioning Evaporator and Blower Module Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Reposition the seat as necessary to access the retaining clips.
Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Extension Panel - Left Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Extension Panel - Right Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Bolt (1) - Remove [6x]
Front Floor Console Bracket Bolt (2) - Remove [2x]
Release the tabs (3) on both sides of the front floor console.
Courtesy of GENERAL MOTORS COMPANY

Slide the front floor console (1) enough to clear the instrument panel lower center trim panel.
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Variable 1 Liner (1) - Remove
Front Floor Console Trim Plate Bolt (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Trim Plate (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Automatic Transmission Control Bolt (1) - Remove [4x]
Automatic Transmission Electronic Control (2) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the front floor console wiring harness from the body wiring harness.
With the aid of an assistant, remove the front floor console (1) from the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Electronic Transmission Range Selector Manual Park Release Shift Lever Nut (1) - Remove
Front Floor Console Bracket Bolt (2) - Remove
Electronic Transmission Range Selector Manual Park Release Cable Grommet Bolt (3) - Remove [2x]
Using a suitable tool, remove the retainer. (4)
Electronic Transmission Range Selector Manual Park Release Cable (5) - Remove