Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connector.
Automatic Transmission Manual Shift Auxiliary Position Switch-Left Side (1) - Install
Steering Wheel Shroud (1) - Install
- Connect the electrical connectors.
- CAUTION:
Steering Wheel Bolt (1) @ Steering Wheel Shroud - Install and tighten [4x] - Fastener Specifications
Steering Wheel Bolt (1) @ Automatic Transmission Manual Shift Auxiliary Position Switch - Install and tighten [4x]
- For vehicles equipped with MQA transmission, refer to Fastener Specifications .
- For vehicles equipped with M5N transmission, refer to Fastener Specifications .
Steering Wheel (2) - Install
- Prepare the steering wheel bolt (1) for installation as follows:
- Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
- Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
- Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the component.
- Steering Wheel Bolt (1) - Install and tighten - Fastener Specifications
- Connect the electrical connector.
Connect the electrical connectors.
- Install any connector position assurance (CPA) devices or secondary locks.
- Steering Wheel Airbag (2) - Install
- Steering Wheel Airbag Bolt (1) - Install and tighten [2x] - Fastener Specifications
Install the 2 steering wheel airbag access hole covers (1).
- Enable the SIR System. SIR Disabling and Enabling