Final Turbine Shaft Seal Installation

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
1	Turbine Shaft Seal Procedure Flip assembly over so the long shaft is pointing downward. Lube the Turbine Shaft Seal and then install the Turbine Shaft Seal by hand slowly. Ensure the seal is not rolled upon installation. NOTE: Seal robustness may be improved if the sizer is left on until the shaft is installed in the Triple Clutch Housing. Install the DT-52088 Turbine Shaft Seal Sizer over the end of the turbine shaft and seal. The DT-52088 Turbine Shaft Seal Sizer should stay installed for at least 5 minutes before removal. Special Tools DT-52088 Turbine Shaft Seal Sizer Equivalent regional tools: Special Tools

Callout

Component Name

Turbine Shaft Seal

Procedure

Flip assembly over so the long shaft is pointing downward.
Lube the Turbine Shaft Seal and then install the Turbine Shaft Seal by hand slowly. Ensure the seal is not rolled upon installation.

NOTE:

Seal robustness may be improved if the sizer is left on until the shaft is installed in the Triple Clutch Housing.

Install the DT-52088 Turbine Shaft Seal Sizer over the end of the turbine shaft and seal. The DT-52088 Turbine Shaft Seal Sizer should stay installed for at least 5 minutes before removal.

Special Tools
DT-52088 Turbine Shaft Seal Sizer
Equivalent regional tools: Special Tools