LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 V, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Automatic Transmission - 10L60 (MQA) Or 10L80 (MHU) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Output Carrier Assembly and Output Carrier Thrust Bearings Installation (2WD) >> Special Tools

Special Tools

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Equivalent regional tools: Special Tools

  1. GM5443039Courtesy of GENERAL MOTORS COMPANY

    Output Shaft Seal (1) - Install NEW [2x]

  1. GM5405252Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure proper orientation.

    Output Carrier Thrust Bearing Assembly (1) - Install

  2. Apply DT-36850  Transjel Lubricant to the dog bone and bearing (a) before installing the carrier into the case.
  3. Install DT-50921  Output Carrier Lifter (3) and J-26941  Bushing and Bearing Remover (2) to the Output Carrier Assembly (4).
  4. NOTE:

    Ensure transmission is NOT in Park, this will ease in installation.

  5. Output Carrier Assembly (4) - Install
  6. NOTE:

    Ensure proper orientation.

  7. Output Carrier Thrust Bearing Assembly (5) - Install