Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Engine Mount (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do NOT tighten all of the way.

Engine Mount Bolt (2) - Install NEW [2x]
Lower screw jack until the engine sits on the mount.
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) @ Engine Mount (2) - Connect
Remove screw jack and the block of wood under the transmission bell housing
Oil Filter - Install
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Thermal Bypass Valve Gasket (1) - Install NEW [2x]
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Pipe Seal (1) - Install NEW [2x]
Transmission Fluid Cooler Seal (2) - Install NEW
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Inlet and Outlet Pipe (2) - Install
Transmission Fluid Cooler Pipe Nut (1) - Install and tighten
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Pipe Clip Bolt (3) - Install and tighten
Transmission Fluid Cooler Pipe Bolt (2) - Install and tighten
Transmission Fluid Cooler Pipe Connector Bolt (1) - Install and tighten [2x]
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

CAUTION:
Refer to Torque-to-Yield Fastener Caution .

Engine Mount Bolt (2) - Tighten [2x] - Fastener Specifications
Engine Mount Nut (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Heat Shield (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Heat Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Heat Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
A special anti-seize compound is used on the heated oxygen sensor threads. The compound consists of liquid graphite and glass beads. The graphite will burn away, but the glass beads will remain, making the sensor easier to remove. New or service sensors will have the compound already applied to the threads. IF a sensor is removed and is to be reinstalled, the threads MUST have an anti-seize compound applied before installation. Adhesives, Fluids, Lubricants, and Sealers

Using the EN-6179 Heated Oxygen Sensor Remover/Installer, install the heated oxygen sensor (1). Fastener Specifications
Connect the electrical connector.
Check the transmission fluid level. Transmission Fluid Level and Condition Check
Fill the engine oil to the proper level with NEW engine oil.
Start the engine and check for leaks.