Repair Instructions
WARNING: This page is about a different variant/trim than selected.
Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification
- Throttle Inlet Absolute Pressure Sensor Replacement - B111 Turbocharger/Supercharger Boost Pressure Sensor
- For control module replacement, programming, and setup refer to Control Module References
Additional Procedures
Intake System Learned Values Reset - Perform only when the following component/system is replaced or serviced:
- B111 Turbocharger/Supercharger Boost Pressure Sensor - Replaced
- K20 Engine Control Module - Replaced