Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Use a small flat-bladed tool to disengage integral tabs on caro tie down loop bolt cap
Cargo Tie Down Loop Bolt Cap(1) - Remove[2x]
- Cargo Tie Down Loop Bolt(2) - Remove[2x]
- Cargo Tie Down Loop(3) - Remove[2x]
Rear Compartment Floor Panel Trim(1) - Remove
Use a small flat-bladed tool to disengage integral tabs on rear end trim finish panel opening cover (1).
- Rear End Trim Finish Panel Opening Cover(1) - Remove
With a flat bladed plastic trim tool, disengage the integral clips.
- Rear End Trim Finish Panel(1) - Remove
- NOTE:
Carefully manipulate the deck lid hinge opening of the rear compartment side trim past the hinge cover.
Rear Compartment Side Trim Insulator Retainer (1) - Remove[4x]
- Rear Compartment Side Trim-Left Side(2) - Reposition
- Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection
Retaining Tab(1) - Disengage[2x]
- Rear Body Fuse Block Cover(2) - Remove
Loosen the battery positive post clamp nut (1).
- Release the retaining tabs and reposition away the battery distribution fuse block (2).
Battery Hold Down Strap Bolt(1) - Remove
- Battery Hold Down Retainer(2) - Remove
Battery Vent Hose(1) - Remove
Battery Hold Down Bolt(2) - Remove
- Battery Hold Down Retainer(1) - Remove
- Battery(3) - Remove