Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Battery Negative Cable(1) - Install

CAUTION:

Refer to Fastener Caution

Battery Negative Cable Bolt(2)@Rear Bumper Impact Bar Bracket - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Battery Negative Cable(1) - Install
Battery Negative Cable Nut(2)@Battery Monitor Module - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Side Trim-Left Side(2) - Install
Rear Compartment Side Trim Insulator Retainer (1) - Install[3x]
Courtesy of GENERAL MOTORS COMPANY

Rear End Trim Finish Panel(1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear End Trim Finish Panel Opening Cover(1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Panel Trim(1) - Install
Courtesy of GENERAL MOTORS COMPANY

Cargo Tie Down Loop(3) - Install[2x]
Cargo Tie Down Loop Bolt(2) - Install and tighten[2x] - Fastener Specifications
Cargo Tie Down Loop Bolt Cap(1) - Install[2x]