Installation Procedure
Oil Pump Flow Control Solenoid Valve (2) - Install
- Oil Pump Flow Control Solenoid Valve Bolt (1) - Install and tighten - Fastener Specifications
- Electrical Connector @ Oil Pump Flow Control Solenoid Valve - Connect
Wipe the oil pan surface with the Adhesion Plastic Pan Primer Promoter using a clean shop towel. Allow the cleaner to flash / evaporate. Wipe off the sealing surfaces with a lint free cloth. Do not touch the sealing surface after cleaning to avoid inducing containment debris to the bonding surface area. Adhesives, Fluids, Lubricants, and Sealers
- Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
- Apply a 3 mm bead of sealant (1) around the seal bead path, as shown.
Install EN-52483 Guide Pin in two locations to keep oil pan square and aid in alignment.
- Oil Pan (1) - Install
- Lower Oil Pan Bolt (2) - Install [4x]
- EN-52483 Guide Pin - Remove [2x]
- Lower Oil Pan Bolt (2) - Install [16x]
- Lower Oil Pan Bolt (2) - Tighten in sequence [20x] - Fastener Specifications
- Engine Wiring Harness Retainer @ Lower Oil Pan - Connect
Front Compartment Air Deflector (2) - Install
- Front Compartment Air Deflector Bolt (1) - Install and tighten [4x] - Fastener Specifications
Front Wheelhouse Liner Bolt (3) - Install and tighten - Fastener Specifications
- Engine Front Splash Shield Retainer (2) - Install [2x]
- Engine Front Splash Shield Bolt (1) - Install and tighten - Fastener Specifications
Front Wheelhouse Liner Bolt (1) - Install and tighten - Fastener Specifications
- Engine Front Splash Shield Retainer (2) - Install [2x]
- Engine Front Splash Shield Bolt (3) - Install and tighten - Fastener Specifications
Front Bumper Fascia Center Air Deflector Retainer (2) - Install [2x]
- Front Bumper Fascia Center Air Deflector Bolt (1) - Install and tighten [5x] - Fastener Specifications
{ If equipped } Front Crossmember Brace (2) - Install
- { If equipped } Front Crossmember Brace Nut (1) - Install and tighten [4x] - Fastener Specifications
- Fill the engine oil to the proper level with NEW engine oil. Engine Oil and Oil Filter Replacement (RWD)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
Refer to Fastener Caution .
Do not allow sealant to skim over, the oil pan must be installed within 8 minutes of sealer application.
Install some lower oil pan bolts to secure the oil pan.
Install the remaining lower oil pan bolts.
Refer to Fastener Caution