Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Remove the oil fill cap.
Intake Manifold Cover Bolt (1) - Remove [2x]
- Lift up on the front of the intake manifold cover (2).
Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Remove
Electrical Connector (1) - Disconnect as necessary
Upper Intake Manifold Cover Nut (1) - Remove [2x]
- Radiator Surge Tank Inlet Hose Clip (2) @ Upper Intake Manifold Bracket (3) - Remove
Upper Intake Manifold Cover Nut (1) - Remove [2x]
- Upper Intake Manifold Bracket (2) - Remove
Fuel Pump Shield Bolt (1) - Remove [2x]
- Fuel Pump Shield Bolt (2) - Remove [2x]
- Fuel Injection Pump Bracket (3) - Remove
- WARNING:
The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death.
Fuel Pump Insulator (1) - Remove