Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the oil fill cap.
Intake Manifold Cover Bolt (1) - Remove [2x]
- Lift up on the front of the intake manifold cover (2).
Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Remove
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
- NOTE:
Quantity of fasteners may vary based on option content.
Front Tire Front Air Deflector Bolt (1) - Remove [4x]
- Front Tire Front Air Deflector (2) - Remove
Front Bumper Fascia Air Deflector Bolt (1) - Remove [3x]
- Front Bumper Fascia Bolt (2) - Remove [2x]
- NOTE:
- Quantity of fasteners may vary based on option content.
- Components removed for graphic clarity.
Engine Front Splash Shield Retainer (2) - Remove [2x]
- Engine Front Splash Shield Bolt (1) - Remove [5x]
- Engine Front Splash Shield (3) - Remove
- NOTE:
Components removed for graphic clarity.
Front Wheelhouse Liner Bolt (1) - Remove [7x]
- Front Wheelhouse Liner Retainer (2) - Remove [4x]
- Front Wheelhouse Liner (3) - Remove
Retainer Spring (1) - Release
- Charge Air Cooler Inlet Air Tube (2) @ Charge Air Cooler (3) - Remove
- Lower the vehicle.
Wiring Harness Retainer (1) @ Air Cleaner Assembly - Remove [4x]
- Positive Crankcase Ventilation Tube (2) - Disconnect - Plastic Collar Quick Connect Fitting Service
- Evaporative Emission Canister Purge Tube (3) - Disconnect - Plastic Collar Quick Connect Fitting Service
- Electrical Connector (4) - Disconnect [2x]
Air Cleaner Bolt (1) - Remove
- Air Cleaner Outlet Duct Clamp (2) - Loosen
Remove the air cleaner (1) and air cleaner outlet duct (2) as an assembly.
Retainer Spring (1) - Release
- Charge Air Cooler Inlet Air Tube (2) @ Turbocharger (3) - Remove
- Charge Air Cooler Inlet Air Tube - Remove