Installation Procedure
- WARNING:
The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death.
Fuel Pump Insulator (1) - Install
Fuel Pump Cover (2) - Install
- Fuel Pump Shield Bolt (1) - Install and tighten [3x] - Fastener Specifications
Fuel Feed Pipe (1) @ Fuel Pump - Connect - Metal Collar Quick Connect Fitting Service
- Reposition wiring harness as necessary.
Radiator Surge Tank Outlet Pipe (3) - Reposition
- Radiator Surge Tank Inlet Hose Clip (1) @ Radiator Surge Tank Inlet Pipe Bracket - Install
- Radiator Surge Tank Inlet Hose Clip (2) @ Radiator Surge Tank Inlet Pipe Bracket - Install
Radiator Surge Tank Inlet Hose Clip (2) @ Engine Wiring Harness - Install
- Radiator Surge Tank Inlet Hose Clip (1) @ Positive Crankcase Ventilation Hose - Install
- Radiator Surge Tank Inlet Hose Clip (3) @ Fuel Pump Cover - Install
Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Install
- NOTE:
Ensure the intake manifold cover retainers fully engage the intake manifold cover studs.
Push down on the front of the intake manifold cover (1) engaging the intake manifold cover retainers to the intake manifold cover studs.
- Install the oil fill cap.
- Pressurize the fuel system and inspect for leaks.
Refer to Fastener Caution .